PENGARUH BAHAN TAMBAH SIKA VISCOCRETE TERHADAP NILAI KUAT TEKAN DAN LAJU INFILTRASI BETON POROUS

SAPUTRA, BIMA ANUGERAH (2023) PENGARUH BAHAN TAMBAH SIKA VISCOCRETE TERHADAP NILAI KUAT TEKAN DAN LAJU INFILTRASI BETON POROUS. Diploma thesis, Politeknik Negeri Balikpapan.

[thumbnail of Judul dan Abstrak.pdf] Text
Judul dan Abstrak.pdf

Download (728kB)
[thumbnail of BAB 1-3.pdf] Text
BAB 1-3.pdf
Restricted to Registered users only

Download (752kB)
[thumbnail of BAB 4.pdf] Text
BAB 4.pdf
Restricted to Registered users only

Download (628kB)
[thumbnail of BAB 5.pdf] Text
BAB 5.pdf

Download (195kB)
[thumbnail of Daftar Pustaka.pdf] Text
Daftar Pustaka.pdf

Download (192kB)

Abstract

ABSTARTC
Indonesia will move the State Capital (IKN) to East Kalimantan, with the
transfer of the State Capital there will be a lot of road infrastructure development.
However, poor drainage conditions will result in standing water when conditions
of high rainfall are accompanied by the cleanliness of the surrounding environment
which is not maintained. To avoid the problems that occur, an innovation is needed
in the construction of road infrastructure using porous concrete or porous concrete.
This study aims to determine the characteristics of porous concrete which includes
compressive strength and infiltration rate values. It is hoped that the results of this
study can support the construction of facilities and infrastructure for the State
Capital in East Kalimantan.
This research was conducted to determine the value of compressive strength
and infiltration rate in porous concrete using aggregates measuring 1-2 cm and 2-
3 cm with aggregate variations of 1/2 100% with added ingredients, 1/2 100%
without added ingredients, 2/ 3 100% with added ingredients, 2/3 100% without
added ingredients, 1/2 50% 2/3 50% with added ingredients, 1/2 50% 2/3 50%
without ingredients. The added material used is Sica Viscocrete 3155 N with the
use of 1% by weight of cement. Treatment on porous concrete is soaked for 28 days
to find maximum strength.
From the results of research carried out by varying the aggregate 1/2 100
SC, the highest average compressive strength was 7,12 MPa with an infiltration
rate of 22005,12 mm/hour. For the mixture that has the lowest average compressive
strength of 2/3 100 TS, it gets a compressive strength of 0,58 MPa with an
infiltration rate of 21554.98 mm/hour, an aggregate mixture of 50 TS and 50 SC
gets the same average compressive strength. of 1,92 MPa with an infiltration rate
of 21989,28 mm/hour for 50 TS and 20568,39 for 50 SC. With the test results, the
increase in compressive strength of concrete added by Sica Viscocrete was seen to
be greater in 100% 2/3 mixed porous concrete, while an increase in infiltration was
15% for 100% 2/3 mixture.
Keywords : Porous concrete, compressive strength, infiltration rate
vii
ABSTRAK
Indonesia akan memindahkan Ibu Kota Negara (IKN) ke Kalimantan Timur,
dengan adanya pemindahan Ibu Kota Negara tersebut maka akan banyak
pembangunan infrastruktur jalan. Namun kondisi drainase yang kurang baik akan
mengakibatkan timbulnya genangan air saat kondisi curah hujan yang tinggi
disertai kebersihan lingkungan sekitar yang tidak terjaga. Untuk menghindari
permasalahan yang terjadi maka diperlukan sebuah inovasi dalam pembangunan
infrastruktur jalan dengan menggunakan beton porous atau beton pori. Penelitian
ini bertujuan untuk mengetahui karakteristik dari beton porous yang meliputi nilai
kuat tekan dan nilai laju infiltrasi, diharapkan hasil penelitian ini dapat mendukung
pembangunan sarana dan prasarana Ibu Kota Negara di Kalimantan Timur.
Penelitian ini dilakukan untuk mengetahui nilai kuat tekan dan laju infiltrasi
pada beton porous yang menggunakan agregat berukuran 1-2 cm dan 2-3 cm
dengan variasi agregat 1/2 100% dengan bahan tambah, 1/2 100% tanpa bahan
tambah, 2/3 100% dengan bahan tambah, 2/3 100% tanpa bahan tambah, 1/2 50%
2/3 50% dengan bahan tambah, 1/2 50% 2/3 50% tanpa bahan. Bahan tambah yang
digunakan yaitu, Sica Viscocrete 3155 N dengan penggunaan 1% dari berat semen.
Perawatan pada beton porous direndam selama 28 hari untuk menemukan kekuatan
maksimal.
Dari hasil penelitian yang dilakukan variasi agregat 1/2 100 SC memiliki
hasil rata-rata kuat tekan tertinggi sebesar 7,12 MPa dengan nilai laju infiltrasi
30027,29 mm/jam. Untuk campuran yang memiliki hasil rata-rata kuat tekan
terendah 2/3 100 TS mendapatkan kuat tekan sebesar 0,58 MPa dengan nilai laju
infiltrasi 21554,98 mm/jam, campuran agregat 50 TS dan 50 SC mendapatkan rata�rata kuat tekan yang sama sebesar 1,92 MPa dengan nilai laju infiltrasi 21989,28
mm/jam untuk 50 TS dan 20568,39 untuk 50 SC. Dengan hasil pengujian
peningkatan kuat tekan beton yang ditambahkan Sica Viscocrete terlihat lebih besar
pada beton porous campuran 2/3 100%, sedangkan peningkatan infiltrasi sebesar
15% untuk campuran 2/3 100% dan mengalami penurunan di campuran yang lain.
Kata kunci : Beton porous, Kuat tekan, Laju infiltrasi

Item Type: Thesis (Diploma)
Divisions: JURUSAN TEKNIK SIPIL > TEKNIK SIPIL
Depositing User: Admin Perpustakaan Poltekba
Date Deposited: 13 May 2026 03:48
Last Modified: 13 May 2026 03:48
URI: http://repository.poltekba.ac.id/id/eprint/220

Actions (login required)

View Item
View Item